Breastfeeding Shirt

Project Description

What are you most proud of? It turned out really cute and makes me feel more feminine than the commercial big-lady-wrapped-in-fabric-origami maternity tops. And it cost $5 for each shirt, plus bits & bobs from my craft room, and was done in the time it took my husband to have breakfast and change the baby! What advice would you give someone starting this project? 1) Look for a singlet with narrower shoulder straps - about 1 inch would be best. I didn't want to use more than 1 snap on each side, but the straps are so wide they really should have 2 to keep the corners flat. 2) It probably looks best if the 2 shirts are the same length or the inside one is shorter - I used what I could find, so the inside one is slightly longer and it looks a little odd. 3) Make sure your lace is sturdy enough to survive being pulled - I've used this trick before, and some lace will break apart under the strain. You could use hat elastic instead of ribbon to reduce the strain if you want. 4) If I had been able to find a singlet with narrow straps, I would have put the snaps about 2 inches forward of the shoulder seam - being right at the top, the bulk is visible and it may get uncomfortable wearing a backpack or sling over the top.

What you will need

  • 2 white shirts from Kmart - one singlet (sleeveless/"tank")
  • one 3/4 sleeve; offcut of white jersey approx 20cm x 10cm; white sewing thread; sewing machine; white snaps; approx 1m white lace with small holes in; approx 1m narrow ribbon

Q&A with A.A.

No completed Q&As yet.